21

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ADJUSTMENTS

SPEED CONTROL

The speed control has 6 speeds.

Determine the optimal setting by

testing on a scrap piece of wood.

NOTE: The use of the correct setting

will increase the life-span of

the cutter. It, also affects the

quality of the cut.

RAISING/LOWERING THE CUTTER

To raise or lower the spindle height.

1. Loosen the securing screw.

2. Use the handle to raise or lower

the spindle to the required height.

3. Tighten the securing screw.

ADJUSTING THE FENCE

1. Loosen the plastic cap screws

shown on the back of the fence.

2. Move the fence to the desired

position.

3. Re-tighten the plastic cap screws

to keep the fence in this position.