10

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

MAINTENANCE

BEFORE USE

1. Always inspect the machine before use for any damage.

2. Ensure all fixing screws remain tight to ensure the tool is in safe working

condition.

3. Inspect the power cable to ensure it is free from cracks or bare wires etc.

CLEANING

1. Ensure all air ventilation slots are clear, (Use compressed air to clean the

tool if possible. Always wear protective goggles and a mask when

cleaning with compressed air).

2. Clean the exterior of the machine with a soft cleaning cloth. Never use any

chemicals or abrasives. Avoid using solvents when cleaning plastic parts,

which may be susceptible to damage from commercial solvents.

GENERAL MAINTENANCE

1. Occasionally inspect the motor

brushes and replace if necessary

after unscrewing the cover plate.

• When removing brushes, note

which way round they are. The

brushes must be returned

exactly as they are removed,

DO NOT swap over positions

etc.

2. A pair of long nosed electricians

pliers will be required to remove and replace the brushes. Pull the

connecting wire off the terminal. Lift up the retaining spring and carefully

rest the spring on one side of the brush holder while changing brushes.

• All bearings etc, in this tool are lubricated with sufficient high grade

lubricant for the machine lifetime under normal operating

conditions, therefore no further lubrication is necessary.

• Refer to your CLARKE dealer if internal maintenance is required.

WARNING: BEFORE COMMENCING ANY MAINTENANCE PROCEDURES,

ALWAYS ENSURE THE SANDER/POLISHER IS ISOLATED FROM THE

ELECTRICAL SUPPLY BY SWITCHING OFF AND REMOVING THE PLUG FROM

THE POWER SOCKET.