30 )

15 ) External Capacitor.

For frequencies from 5.0 to 8.0MHz it is recommended to use ZTACC MG series as the characteristics are better.

Most frequencies of the ZTA CS will eventually be phased out in favour of the smaller package devices. For new

applications the ZTACV MT is recommended for frequencies from 8 to 13MHz and the ZTACV MX for 16 to 60MHz.

W1

5.1±0.2

3 The Business Centre, Molly Millars Lane, Wokingham, Berkshire, RG41 2EY, UK

http://www.actcrystals.com

CD4069UBE x 2

For quotations or further information please contact us at:

± 0.5

5.00 ~ 13.00

± 0.3

Please note that all parameters can not necessarily be specified in the same device

26.00 ~ 50.00

Frequency

Number

Range (MHz)

(-20 ~ +80 °C)

C1 & C2

The ACT ZTACS family comprise of a range of surface mount, ceramic

resonators ("chip" type) in two pad format. This family offers a cost effective

solution to those applications where a wide temperature range, accuracy to ± 0.5,

small size and surface mounting are the requirements.

Aging over

Part Type/

Specification

Tel :

0044 (0)118 979 1238

Fax :

0044 (0)118 979 1283

email :

info@actcrystals.com

Ten Year (%)

Capacitors (pF)

(Ext. & Int.l)

ACT ZTACS SMD Resonators

Test IC

Frequency

Accuracy (%)

In line with our ongoing policy of product evolvement and improvement, the above specification may be subject to change without notice

ISO9001:2000 Registered

74HCU04 x 2

Pad material Sn

20.01 ~ 25.99

13.01 ~ 20.00

50.01~ 60.00

Specification may vary from above please enquire

T2

0.8±0.2

30

External Capacitor.

Customer to specify : Frequency

± 0.5

± 0.3

5 )

ZTACS MX

ZTACS MT

P2

0.8±0.4

1.6±0.3

ZTACS MG

4.7±0.2

L

T3

1.95±0.2

Stability over

temp. range

(-20 ~ +80°C)

± 0.4%

± 0.4%

H

W

4.1±0.2

Important note when using Ceramic resonators with micro controllers:

Some resonator parameters vary considerably with frequency and physical construction/size . These differences are too

great to be able to be practically shown in a data sheet.

However, these parameters can be critical when the resonators are used with micro controllers. Even if two different

resonators appear to have the same specification the typical values of these critical parameters can be considerably

different. When enquiring about resonators for use with micro controllers it is important to supply the make and part

number of the IC to be used and/or the list of recommended resonators, if this is given.

Issue : 8 C1r

Date :28/06/06

The piezo electric ceramic contains lead greater than the

RoHS limit as an inapplicability substance. Excluded from

RoHS legislation