M95010-RBN6 datasheet(9/37 Pages) STMICROELECTRONICS

9 / 37 page

9/37

M95040, M95020, M95010

OPERATING FEATURES

Power-up

When the power supply is turned on, VCC rises

from VSS to VCC.

During this time, the Chip Select (S) must be al-

lowed to follow the VCC voltage. It must not be al-

lowed to float, but should be connected to VCC via

a suitable pull-up resistor.

As a built in safety feature, Chip Select (S) is edge

sensitive as well as level sensitive. After Power-

up, the device does not become selected until a

falling edge has first been detected on Chip Select

(S). This ensures that Chip Select (S) must have

been High, prior to going Low to start the first op-

eration.

Power-down

At Power-down, the device must be deselected.

Chip Select (S) should be allowed to follow the

voltage applied on VCC.

Active Power and Standby Power Modes

When Chip Select (S) is Low, the device is select-

ed, and in the Active Power mode. The device

consumes ICC, as specified in Table 13. to Table

17..

When Chip Select (S) is High, the device is dese-

lected. If an Erase/Write cycle is not currently in

progress, the device then goes in to the Standby

Power mode, and the device consumption drops

to ICC1.

Hold Condition

The Hold (HOLD) signal is used to pause any se-

rial communications with the device without reset-

ting the clocking sequence.

During the Hold condition, the Serial Data Output

(Q) is high impedance, and Serial Data Input (D)

and Serial Clock (C) are Don’t Care.

To enter the Hold condition, the device must be

selected, with Chip Select (S) Low.

Normally, the device is kept selected, for the whole

duration of the Hold condition. Deselecting the de-

vice while it is in the Hold condition, has the effect

of resetting the state of the device, and this mech-

anism can be used if it is required to reset any pro-

cesses that had been in progress.

The Hold condition starts when the Hold (HOLD)

signal is driven Low at the same time as Serial

Clock (C) already being Low (as shown in Figure

6.).

The Hold condition ends when the Hold (HOLD)

signal is driven High at the same time as Serial

Clock (C) already being Low.

Figure 6. also shows what happens if the rising

and falling edges are not timed to coincide with

Serial Clock (C) being Low.

Figure 6. Hold Condition Activation

AI02029D

HOLD

Hold

Condition

Hold

Condition

M95010-RBN6 数据表(PDF) 9 Page - STMicroelectronics

M95010-RBN6 数据表(HTML) 9 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37

数据表下载