G-213

D4NH

Arm Lever Type with 2 Conduits

Note: 1. Unless otherwise specified, a tolerance of

0.4 mm applies to all dimensions.

2. Variation occurs in the simultaneity of contact opening/closing operations of 2NC, 2NC/1NO, and 3NC contacts. Check contact operation.

3. There are a minimum of five turns of the screw thread for a Pg13.5 conduit opening and four turns minimum for a G 1/2 conduit opening.

4. Refer to the following diagram for details on M12 connectors.

1-conduit M12 Connector

Application Examples of Arm Lever Use

Note: Be sure to evaluate the Switch under actual working conditions after installation.

Red

Black

20.5

×20.5

25 dia.

2.15

±0.05R

mounting holes

Conduit cap

(See note 3.)

0

Two, 4

+0.15 dia. holes

Depth: 5

Cap

22

±0.1

20

±0.1

42

±0.1

40

±0.1

56 max.

(3)

42

±0.2

18

47

20.5

29

±1

43

80

27.5

(26.7)

(10.3)

1.5

11

±0.2

21.5

5.1

16

5.4

39

±0.2

9

±0.2

2.5

14.2

(16.5)

(37.9)

D4NH-5

@BC

D4NH-6

@BC

D4NH-7

@BC

D4NH-8

@BC

OF max.

0.15 N·m

PT 1 (NC)

PT 2 (NO)

(7

) (MBB: 10)

(19

) (MBB: 5)

DOT min.

DOF min.

18



1 N·m

(14)

M12

×1

14.2

30

D4NH-9

@@@

When Installing at the Center

The arm lever is set for center installation

at the time of shipment.

When Installing to the Left

Remove the screw and arm lever, position

the arm lever to the left, and then secure it

with the screw.

When Installing to the Right

Remove the screw and arm lever, position

the arm lever to the right, and then secure

it with the screw.

Note: Install the arm lever so that it will not ro-

tate more than 90

.

Note: Install the arm lever so that it will not ro-

tate more than 180

.

Note: Install the arm lever so that it will not ro-

tate more than 180

.