E32-R16 datasheet(36/38 Pages) OMRON

36 / 38 page

E3X-NH

Do not apply excess force on the Fiber Units.

Fiber Unit

Nylon wireholder

Correct

Incorrect

Metal holder

The Fiber Head could be break by excessive vibration. To prevent

this, the following is effective:

Bending Radius

E39-F11 Sleeve Bender

The bending radius of the stainless tube should be as large as pos-

sible. The smaller the bending radius becomes, the shorter the

sensing distance will be.

Insert the tip of the stainless tube to the Sleeve Bender and bend the

stainless tube slowly along the curve of the Sleeve Bender (refer to

the figure).

Fiber tip position mark

Do not bend here.

1.2 dia.

max.

1.3 dia.

min.

1.2 dia.

max.

R 12.5

R 7.5

R 10

R 5

Stainless tube

90o max.

Amplifier Units

Mounting

1. Mount the front part on the mounting bracket (attachment) or

a DIN track.

2. Press the back part onto the mounting bracket or the DIN

track.

Note:

Do not mount the back part onto the mounting bracket or

the DIN track first and then mount the front part on the

mounting bracket or the DIN track, or the mounting strength

of the Amplifier Unit may decrease.

(1)

DIN track

Dismounting

By pressing the Amplifier Unit in direction (3) and lifting the fiber in-

sertion part in direction “4” as shown in the following, the Amplifier

can be dismounted with ease.

(3)

In the case of side mounting, attach the mounting bracket on the

Amplifier first, and secure the Amplifier with M3 screws and wash-

ers. The diameter of the washers should be 6 mm max.

Tape

A one-turn loop can

absorb vibrations

(4)

DIN track

(2)

Washers

(6 dia. max.)

E32-R16 数据表(PDF) 36 Page - Omron Electronics LLC

E32-R16 数据表(HTML) 36 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

数据表下载