G6W

G6W

SMD-type substrate

Note:

When higher isolation is required, connect the convex

position on the undersurface of the relay to the ground

pattern of the substrate by soldering.

Base plate for high-frequency characteristic compensation

Note:

The above compensation plate is used to measure the

loss by the relay.

The relay loss is determined by subtracting the data

measured for a compensation base plate from those for a

high-frequency characteristics measuring substrate

mounted with a relay.

Handling

Leave the Relays packed until just prior to mounting them.

Soldering

Solder: JIS Z3282, H63A

Soldering temperature: Approx. 250ºC (At 260ºC if the DWS

method is used.)

Soldering time: Approx. 5 s max. (approx. 2 s for the first time and

approx. 3 s for the second time if the DWS method is used.)

Be sure to adjust the level of the molten solder so that the solder

will not overflow onto the PCB.

Claw Securing Force During Automatic Insertion

During automatic insertion of Relays, make sure to set the

securing force of the claws to the following values so that the

Relay characteristics will be maintained.

Environmental Conditions During Operation, Storage, and

Transportation

Protect the Relays from direct sunlight and keep the Relays under

normal temperature, humidity, and pressure.

Latching Relay Mounting

Make sure that the vibration or shock that is generated from other

devices, such as relays in operation, on the same panel and

imposed on the Latching Relay does not exceed the rated value,

otherwise the Latching Relay that has been set may be reset or

vice versa.

The Latching Relay is reset before shipping.

If

excessive vibration or shock is imposed, however, the Latching

Relay may be set accidentally. Be sure to apply a reset signal

before use.

Coating

Relays mounted on PCBs may be coated or washed. Do not

apply silicone coating or detergent containing silicone, otherwise

the silicone coating or detergent may remain on the surface of the

Relays.

Convex position

15.24

5.12

1.8

1.5

0.5

1.4

0.4

8.6

3

Thirty one, 0.6-dia.,

through-hole

1.5

6

0.5

3

Undersurface of relay

Through-

hole

15

0.5

13.6

1.5

2

Twenty four, 0.6-dia.,

through-hole

Secure the claws to the area indicated by shading.

Do not attach them to the center area or to only part of the

Relay.

A

C

B

Direction A: 4.90 N max.

Direction B: 9.80 N max.

Direction C: 9.80 N max.

In the interest of product improvement, specifications are subject to change without notice.

ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.

To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.

Cat. No. K120-E1-01

OMRON Corporation

Electronic Components Company

Electronic & Mechanical Components Division H.Q.

Low Signal Relay Division

2-1, 2-Chome, Nishikusatsu, Kusatsu-City,

Shiga, 525-0035 Japan

Tel: (81)77-565-5481/Fax: (81)77-565-5581

Printed in Japan

0402-2M (0402) (B)