Physical specifications

WARNINGS

•

This product should only be connected to an external power supply rated at 5 V/2.5 A DC. Any external

power supply used with the Raspberry Pi 3 Model A+ shall comply with relevant regulations and

standards applicable in the country of intended use.

•

This product should be operated in a well-ventilated environment and, if used inside a case, the case

should not be covered.

•

While in use, this product should be placed on a stable, flat, non-conductive surface and should not be

contacted by conductive items.

•

The connection of incompatible devices to the GPIO connection may affect compliance, result in

damage to the unit, and invalidate the warranty.

•

All peripherals used with this product should comply with relevant standards for the country of use

and be marked accordingly to ensure that safety and performance requirements are met. These

articles include but are not limited to keyboards, monitors, and mice when used in conjunction with the

Raspberry Pi.

•

The cables and connectors of all peripherals used with this product must have adequate insulation so

that relevant safety requirements are met.

SAFETY INSTRUCTIONS

To avoid malfunction or damage to this product, please observe the following:

•

Do not expose to water or moisture, or place on a conductive surface while in operation.

•

Do not expose to heat from any source; the Raspberry Pi 3 Model A+ is designed for reliable operation

at normal ambient temperatures.

•

Do not expose the printed circuit board to high-intensity light sources (e.g. xenon flash or laser) whilst

in operation.

•

Take care while handling to avoid mechanical or electrical damage to the printed circuit board

and connectors.

•

While it is powered, avoid handling the printed circuit board, or only handle it by the edges to minimise

the risk of electrostatic discharge damage.

all dimensions in mm

4

Raspberry Pi 3 Model A+ Product Brief