12/31/2018

Diecast Aluminum Enclosures (1590-RIBBED Series) - Hammond Mfg.

https://www.hammfg.com/electronics/small-case/diecast/1590-ribbed

1/2

Replacement Hardware

Tamper-proof Hardware Upgrade (Torx w/

Pin)

Each kit includes two pre-formed silicone gaskets.

Gaskets include adhesive backing for easy installation.

Allows enclosure to be machined and/or painted first and

gasketed later.

Gasket is applied to the lid.

Designed to meet IP65 with properly installed gasket and lid

screws torqued to 25-30 cN.m (36-43 ozf.in).

Refer to part number table below for correct gasket.

Diecast Aluminum Enclosures 1590-RIBBED Series

With Internal Ribs

Features

Rugged, diecast aluminum alloy (tough - yet easy to machine), electronic instrument

enclosure.

Lap joint construction provides protection against access of dust and splashing water.

Also provides for improved EMI/RFI shielding.

Unpainted version is vibra finished for a smooth surface with no sharp edges.

Satin black painted version is painted with tough polyester powder paint for a lasting

finish, even after machining. Black screws are included to enhance appearance.

Includes screws threaded into factory-tapped holes. Screw type and quantity vary. See

details below or in drawings.

Standard versions are designed to meet IP54.

Water-tight versions are designed to meet IP65.

Low side wall draft angle (2 degrees or less) for easy P.C. board mounting.

Hardware

NOTE: 1590 series enclosures feature factory-tapped assembly screw holes that accept machine

screws, which are included with the enclosures.

See "Hardware" table below for compatibility.

Gaskets

NOTE: Gaskets are included with watertight 1590 enclosures. They can also be purchased as a

kit if you'd like to upgrade an IP54 enclosure to IP65. Not available for all sizes.

Notes

Lid height is 0.16" (4 mm).

Quality Products. Service Excellence.