ST72321 datasheet(123/185 Pages) STMICROELECTRONICS

123 / 185 page

ST72321

123/185

I2C BUS INTERFACE (Cont’d)

I2C CLOCK CONTROL REGISTER (CCR)

Read / Write

Reset Value: 0000 0000 (00h)

Bit 7 = FM/SM

Fast/Standard I2C mode.

This bit is set and cleared by software. It is not

cleared when the interface is disabled (PE=0).

0: Standard I2C mode

1: Fast I2C mode

Bit 6:0 = CC[6:0]

7-bit clock divider.

These bits select the speed of the bus (FSCL) de-

pending on the I2C mode. They are not cleared

when the interface is disabled (PE=0).

– Standard mode (FM/SM=0): FSCL <= 100kHz

FSCL = FCPU/(2x([CC6..CC0]+2))

– Fast mode (FM/SM=1): FSCL > 100kHz

FSCL = FCPU/(3x([CC6..CC0]+2))

Note: The programmed FSCL assumes no load on

SCL and SDA lines.

I2C DATA REGISTER (DR)

Read / Write

Reset Value: 0000 0000 (00h)

Bit 7:0 = D[7:0]

8-bit Data Register.

These bits contain the byte to be received or trans-

mitted on the bus.

– Transmitter mode: Byte transmission start auto-

matically when the software writes in the DR reg-

ister.

– Receiver mode: the first data byte is received au-

tomatically in the DR register using the least sig-

nificant bit of the address.

Then, the following data bytes are received one

by one after reading the DR register.

FM/SM

CC6

CC5

CC4

CC3

CC2

CC1

CC0

ST72321 数据表(PDF) 123 Page - STMicroelectronics

ST72321 数据表(HTML) 123 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载