ADA4505-2

Rev. 0 | Page 15 of 20

The charge pump has been carefully designed so that switching

noise components at any frequency, both within and beyond the

amplifier bandwidth, are much lower than the thermal noise floor.

Therefore, the spurious-free dynamic range (SFDR) is limited

only by the input signal and the thermal or flicker noise. There

is no intermodulation between input signal and switching noise.

Figure 50 displays a typical front-end section of an operational

amplifier with an on-chip charge pump.

Q2

Q1

+IN

–IN

OUT

CASCODE

STAGE

AND

RAIL-TO-RAIL

OUTPUT

STAGE

Figure 50. Typical Front-End Section of an Op Amp

with Embedded Charge Pump

Figure 51, input offset voltage vs. input common-mode voltage

response, shows the typical response of two devices from Figure 7.

Figure 51 has been expanded so that it is easier to compare with

Figure 49, typical input offset voltage vs. common-mode voltage

response in a dual differential pair input stage op amp.

0

–300

–100

100

300

1.5

3.5

5.0

1.0

0.5

2.5

4.5

4.0

3.0

2.0

–200

–150

–250

–50

0

50

150

200

250

Figure 51. Input Offset Voltage vs. Input Common-Mode Voltage Response

(Powered by a 5 V Supply; Results of Two Units Are Displayed)

This solution improves the CMRR performance tremendously.

For instance, if the input varies from rail-to-rail on a 2.5 V

supply rail, using a part with a CMRR of 70 dB minimum, an

input-referred error of 790 μV is introduced. Another part with

a CMRR of 52 dB minimum generates a 6.3 mV error. The

ADA4505-2 CMRR of 90 dB minimum causes only a 79 μV

error. As with the PSRR error, there are complex ways to minimize

this error, but the ADA4505-2 solves this problem without

incurring unnecessary circuitry complexity or increased cost.