| 数据搜索系统,热门电子元器件搜索 |
|
TPS2829MDBVREP 数据表(PDF) 15 Page - Texas Instruments |
|
|
|||||||||||||||||||||||||||||
TPS2829MDBVREP 数据表(HTML) 15 Page - Texas Instruments |
|
15 / 24 page ![]() www.ti.com APPLICATION INFORMATION Regulator 0.1 µF 1 2 3 5 4 Input TPS2816 VCC Load Regulator 4.7 µF 1 2 3 5 4 Input TPS2816 VDD Load 0.1 µF + TPS2816-EP, TPS2817-EP, TPS2818-EP TPS2819-EP, TPS2828-EP, TPS2829-EP SGDS039 – FEBRUARY 2008 MOSFETs are voltage-driven devices that require very little steady-state drive current. However, the large input capacitance (200 pF to 3000 pF or greater) of these devices requires large current surges to reduce the turn-on and turn-off times. The TPS2816 series of high-speed drivers can supply up to 2 A to a MOSFET, greatly reducing the switching times. The fast rise times and fall times and short propagation delays allow for operation in today's high-frequency switching converters. In addition, MOSFETs have a limited gate-bias voltage range, usually less than 20 V. The TPS2816 series of drivers extends this operating range by incorporating an on-board series regulator with an input range up to 40 V. This regulator can be used to power the drivers, the PWM chip, and other circuitry, providing the power dissipation rating is not exceeded. When using these devices, care should be exercised in the proper placement of the driver, the switching MOSFET, and the bypass capacitor. Because of the large input capacitance of the MOSFET, the driver should be placed close to the gate to eliminate the possibility of oscillations caused by trace inductance ringing with the gate capacitance of the MOSFET. When the driver output path is longer than approximately 2 inches, a resistor in the range of 10 Ω should be placed in series with the gate drive as close as possible to the MOSFET. A ceramic bypass capacitor is also recommended to provide a source for the high-speed current transients that the MOSFET requires. This capacitor should be placed between VCC and GND of the driver (see Figure 20 and Figure 21). Figure 20. VCC < 14 V Figure 21. VCC > 14 V The on-board series regulator supplies approximately 20 mA of current at 11.5 V, some of which can be used for Copyright © 2008, Texas Instruments Incorporated Submit Documentation Feedback 15 Product Folder Link(s): TPS2816-EP TPS2817-EP TPS2818-EP TPS2819-EP TPS2828-EP TPS2829-EP |
|
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |