Absolute maximum ratings and operating conditions

LM2904

4/22

2

Absolute maximum ratings and operating conditions

Table 1.

Absolute maximum ratings (AMR)

Symbol

Parameter

Value

Unit

1.

All voltage values, except differential voltage are with respect to network ground terminal.

±16 or 32

V

2.

Differential voltages are the non-inverting input terminal with respect to the inverting input terminal.

±32

V

Input voltage

-0.3 to 32

V

3.

Destructive dissipation can result from simultaneous short-circuits on all amplifiers.

Infinite

s

4.

This input current only exists when the voltage at any of the input leads is driven negative. It is due to the

collector-base junction of the input PNP transistor becoming forward biased and thereby acting as input

diodes clamps. In addition to this diode action, there is also NPN parasitic action on the IC chip. This

for a large overdrive) for the time duration than an input is driven negative. This is not destructive and

normal output will set up again for input voltage higher than -0.3 V.

50

mA

Operating free-air temperature range

-40 to +125

°C

Storage temperature range

-65 to +150

°C

Maximum junction temperature

150

°C

SO-8

TSSOP8

DIP8

MiniSO-8

5.

Short-circuits can cause excessive heating and destructive dissipation. Values are typical.

125

120

85

190

°C/W

Thermal resistance junction to case(5)

SO-8

TSSOP8

DIP8

MiniSO-8

40

37

41

39

°C/W

ESD

6.

Human body model: A 100 pF capacitor is charged to the specified voltage, then discharged through a

1.5 k

Ω resistor between two pins of the device. This is done for all couples of connected pin combinations

while the other pins are floating.

300

V

7.

Machine model: A 200 pF capacitor is charged to the specified voltage, then discharged directly between

two pins of the device with no external series resistor (internal resistor < 5

Ω). This is done for all couples of

connected pin combinations while the other pins are floating.

200

V

8.

Charged device model: all pins and the package are charged together to the specified voltage and then

discharged directly to the ground through only one pin. This is done for all pins.

1.5

kV