STM1001SWX6F datasheet(4/14 Pages) STMICROELECTRONICS

4 / 14 page

STM1001

4/14

OPERATION

Reset Output

The

STM1001

MICROPROCESSOR

RESET

CIRCUIT asserts a reset signal to the MCU when-

ever VCC goes below the reset threshold (VRST).

RST is guaranteed valid down to VCC =1V (0° to

70°C).

During power-up, once VCC exceeds the reset

threshold an internal timer keeps RST low for the

reset time-out period, trec. After this interval, RST

returns high.

If VCC drops below the reset threshold, RST goes

low. Each time RST is asserted, it stays low for at

least the reset time-out period. Any time VCC goes

below the reset threshold, the internal timer clears.

The reset timer starts when VCC returns above the

reset threshold. The active-low reset (RST) is an

open drain output.

Negative-Going VCC Transients

The STM1001 is relatively immune to negative-go-

ing VCC transients (glitches). Figure 11., page 7

shows typical transient duration versus reset com-

parator overdrive (for which the STM1001 will

NOT generate a reset pulse). The graph was gen-

erated using a negative pulse applied to VCC,

starting at 0.5V above the actual reset threshold

and ending below it by the magnitude indicated

(comparator overdrive). The graph indicates the

maximum pulse width a negative VCC transient

can have without causing a reset pulse. As the

magnitude of the transient increases (further be-

low the threshold), the maximum allowable pulse

width decreases. Any combination of duration and

overdrive which lies under the curve will NOT gen-

erate a reset signal. Typically, a VCC transient that

goes 100mV below the reset threshold and lasts

20µs or less will not cause a reset pulse. A 0.1µF

bypass capacitor mounted as close as possible to

the VCC pin provides additional transient immunity.

STM1001SWX6F 数据表(PDF) 4 Page - STMicroelectronics

STM1001SWX6F 数据表(HTML) 4 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14

数据表下载