11/15

TDA7375A

Figure 26. Output Fault Waveforms (see fig. 27)

Figure 27. Fault Waveforms

5.7 HANDLING OF THE DIAGNOSTICS INFORMATION

As various kinds of information is available at the same pin (clipping detection, output fault, thermal prox-

imity), this signal must be handled properly in order to discriminate each event.

This could be done by taking into account the different timing of the diagnostic output during each case.

Normally the clip detector signalling produces a low level at pin 10 that is shorter referred to everyt kind of

fault detection; based on this assumption an interface circuitry to differentiate the information