STLM20

DC and AC characteristics

9/16

4

DC and AC characteristics

This section summarizes the DC and AC characteristics of the device. The parameters in

the DC and AC characteristics table that follows are derived from tests performed under the

test conditions (see Table6 on page9). Designers should check that the operating

conditions in their circuit match the operating conditions when relying on the quoted

parameters.

Table 6.

DC and AC characteristics

Sym

Description

1.

noted).

Min

2.

Max

Unit

Supply voltage

2.4

5.5

V

–40°C to 85°C

2.7

5.5

V

Output voltage

1.8639

V

(–1.15E–2 * T) + 1.8639V

3.

Error accuracy is between the measured and calculated output voltage at specified conditions of voltage,

current, and temperature.

±1.5

°C

±2.5

°C

±2.1

°C

±1.9

°C

±2.3

°C

±2.5

°C

Quiescent current

2.4V

4.8

8

µA

Sensor gain (temperature

sensitivity or average slope),

–30°C

–11.4 –11.77 –12.2

mV/°C

Non-linearity

–20°C

±0.4

%

Change of quiescent current

2.4V

0.7

µA

Temperature coefficient of

quiescent current

–11

nA/°C

Shutdown current

0.02

µA

Output impedance

0µA

4.

With negative current flowing into STLM20 and positive current flowing out, can typically sink less than 1µA

and source is 16µA.

5.

Over the supply range of 2.4 to 5.5V.

160

Ω

RegL

6.

Measured at constant junction temperature, with pulse testing and low duty cycle. Output changes due to

heating may be calculated by multiplying internal dissipation by thermal resistance.

–2.5

mV

RegI1

Line regulation

2.4V

3.3

mV/V

RegI2

5.0V

11

mV