SRI4K datasheet(20/45 Pages) STMICROELECTRONICS

20 / 45 page

SRI4K states

SRI4K

20/45

SRI4K states

The SRI4K can be switched into different states. Depending on the current state of the

SRI4K, its logic will only answer to specific commands. These states are mainly used during

the anticollision sequence, to identify and to access the SRI4K in a very short time. The

SRI4K provides 6 different states, as described in the following paragraphs and in Figure 19.

6.1

Power-off state

The SRI4K is in Power-off state when the electromagnetic field around the tag is not strong

enough. In this state, the SRI4K does not respond to any command.

6.2

Ready state

When the electromagnetic field is strong enough, the SRI4K enters the Ready state. After

Power-up, the Chip_ID is initialized with a random value. The whole logic is reset and

remains in this state until an Initiate() command is issued. Any other command will be

ignored by the SRI4K.

6.3

Inventory state

The SRI4K switches from the Ready to the Inventory state after an Initiate() command has

been issued. In Inventory state, the SRI4K will respond to any anticollision commands:

Initiate(), Pcall16() and Slot_marker(), and then remain in the Inventory state. It will switch to

the Selected state after a Select(Chip_ID) command is issued, if the Chip_ID in the

command matches its own. If not, it will remain in Inventory state.

6.4

Selected state

In Selected state, the SRI4K is active and responds to all Read_block(), Write_block() and

Get_UID() commands. When an SRI4K has entered the Selected state, it no longer

responds to anticollision commands. So that the reader can access another tag, the SRI4K

can be switched to the Deselected state by sending a Select(Chip_ID2) with a Chip_ID that

does not match its own, or it can be placed in Deactivated state by issuing a Completion()

command. Only one SRI4K can be in Selected state at a time.

6.5

Deselected state

Once the SRI4K is in Deselected state, only a Select(Chip_ID) command with a Chip_ID

matching its own can switch it back to Selected state. All other commands are ignored.

6.6

Deactivated state

When in this state, the SRI4K can only be turned off. All commands are ignored.

SRI4K 数据表(PDF) 20 Page - STMicroelectronics

SRI4K 数据表(HTML) 20 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45

数据表下载