I

Data transmission from microprocessor to the

TDA7313 and viceversa takes place thru the 2

wires I

lines SDA and SCL (pull-up resistors to positive

supply voltage must be connected).

Data Validity

As shown in fig. 17, the data on the SDA line

must be stable during the high period of the clock.

The HIGH and LOW state of the data line can

only change when the clock signal on the SCL

line is LOW.

Start and Stop Conditions

As shown in fig.18 a start condition is a HIGH to

LOW transition of the SDA line while SCL is

HIGH. The stop condition is a LOW to HIGH tran-

sition of the SDA line while SCL is HIGH.

Byte Format

Every byte transferred on the SDA line must con-

tain 8 bits. Each byte must be followed by an ac-

knowledge bit. The MSB is transferred first.

Acknowledge

The master (

µP) puts a resistive HIGH level on the

SDA line during the acknowledge clock pulse (see

fig. 19). The peripheral (audioprocessor) that ac-

knowledges has to pull-down (LOW) the SDA line

during the acknowledge clock pulse, so that the

SDA line is stable LOW during this clock pulse.

The audioprocessor which has been addressed

has to generate an acknowledge after the recep-

tion of each byte, otherwise the SDA line remains

at the HIGH level during the ninth clock pulse

time. In this case the master transmitter can gen-

erate the STOP information in order to abort the

transfer.

Transmission without Acknowledge

Avoiding to detect the acknowledge of the audio-

processor, the

µP can use a simplier transmis-

sion: simply it waits one clock without checking

the slave acknowledging, and sends the new

data.

This approach of course is less protected from

misworking and decreases the noise immunity.

Figure 17: Data Validity on the I

Figure 16: Typical Tone Response (with the ext.

components indicated in the test

circuit)

Figure 15: Bass Resistance vs. Temperature

TDA7313

8/14