TDA7403 datasheet(17/26 Pages) STMICROELECTRONICS

17 / 26 page

Automatic Threshold Control

Besides the noise controlled threshold adjust-

ment there is an additional possibility for influenc-

ing the trigger threshold. It is depending on the

stereoblend control.

The point where the MPX signal starts to become

noisy is fixed by the RF part. Therefore also the

starting point of the normal noise-controlled trig-

ger adjustment is fixed (fig. 15). In some cases

the behaviour of the noiseblanker can be im-

proved by increasing the threshold even in a re-

gion of higher fieldstrength. Sometimes a wrong

triggering occures for the MPX signal often shows

distortion in this range which can be avoided

even if using a low threshold.

Because of the overlap of this range and the

range of the stereo/mono transition it can be con-

trolled by stereoblend. This threshold increase is

programmable in 3 steps or switched off with bits

D0 and D1 of the fieldstrength control byte.

Over Deviation Detector

If the system is tuned to stations with a high de-

viation the noiseblanker can trigger on the higher

frequencies of the modulation. To avoid this

wrong behaviour, which causes noise in the out-

put signal, the noiseblanker offers a deviation de-

pendent threshold adjustment.

By rectifying the MPX signal a further signal rep-

resenting the actual deviation is obtained. It is

used to increase the PEAK voltage. Offset and

gain of this circuit are programmable in 3 steps

with the bits D6 and D7 of the stereodecoder byte

(the first step turns off the detector, see fig. 15).

TEST MODE

During the test mode which can be activated by

setting bit D0 of the testing byte and bit D5 of the

subaddress byte to ”1” several internal signals

are available at the CASSR pin.

During this

mode the input resistance of 100kOhm is discon-

nected from the pin. The internal signals available

are shown in the software specification.

+VCC

100nF

CASS R

CASS L

100nF

CASS R

CASS L

OUTRR

OUTLR

OUTRF

OUTLF

CREF

µF

D98AUxx5

LEVEL

SMUTE

SCL

SDA

LEVEL

SMUTE

SCL

SDA

GND

MPX

220nF

MPX

220nF

Figure 23. Application Example.

TDA7403

17/26

TDA7403 数据表(PDF) 17 Page - STMicroelectronics

TDA7403 数据表(HTML) 17 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26

数据表下载