PPC5606BEMLU datasheet(46/98 Pages) FREESCALE

46 / 98 page

MPC560xS Microcontroller Data Sheet Data Sheet, Rev. 1

Preliminary—Subject to Change Without Notice

Electrical Characteristics

Freescale Semiconductor

where:

RθJA = junction to ambient thermal resistance (oC/W)

RθJC= junction to case thermal resistance (oC/W)

RθCA= case to ambient thermal resistance (oC/W)

RθJC s device related and is not affected by other factors. The thermal environment can be controlled to change the

case-to-ambient thermal resistance, RθCA. For example, change the air flow around the device, add a heat sink, change the

mounting arrangement on the printed circuit board, or change the thermal dissipation on the printed circuit board surrounding

the device. This description is most useful for packages with heat sinks where 90% of the heat flow is through the case to heat

sink to ambient. For most packages, a better model is required.

A more accurate two-resistor thermal model can be constructed from the junction-to-board thermal resistance and the

junction-to-case thermal resistance. The junction-to-case thermal resistance describes when using a heat sink or where a

substantial amount of heat is dissipated from the top of the package. The junction-to-board thermal resistance describes the

thermal performance when most of the heat is conducted to the printed circuit board. This model can be used to generate simple

estimations and for computational fluid dynamics (CFD) thermal models.

To determine the junction temperature of the device in the application on a prototype board, use the thermal characterization

parameter (

ΨJT) to determine the junction temperature by measuring the temperature at the top center of the package case using

the following equation:

TJ = TT + (ΨJT x PD)

Eqn. 4

where:

TT= thermocouple temperature on top of the package (oC)

ΨJT= thermal characterization parameter (oC/W)

PD= power dissipation in the package (W)

The thermal characterization parameter is measured in compliance with the JESD51-2 specification using a 40-gauge type T

thermocouple epoxied to the top center of the package case. Position the thermocouple so that the thermocouple junction rests

on the package. Place a small amount of epoxy on the thermocouple junction and approximately 1 mm of wire extending from

the junction. Place the thermocouple wire flat against the package case to avoid measurement errors caused by the cooling

effects of the thermocouple wire.

References:

Semiconductor Equipment and Materials International

805 East

Middlefield Rd.

Mountain View,

CA 94043

(415) 964-5111

MIL-SPEC and EIA/JESD (JEDEC) specifications are available from Global Engineering Documents at 800-854-7179 or

303-397-7956.

JEDEC specifications are available on the WEB at http://www.jedec.org.

PPC5606BEMLU 数据表(PDF) 46 Page - Freescale Semiconductor, Inc

PPC5606BEMLU 数据表(HTML) 46 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98

数据表下载