TS80C32X2-VCKB datasheet(43/54 Pages) TEMIC

43 / 54 page

Rev. B - Jan. 25, 1999

Preliminary

TS80C52X2

Figure 16. Clock Signal Waveform for ICC Tests in Active and Idle Modes

10.4 AC Parameters

10.4.1 Explanation of the AC Symbols

Each timing symbol has 5 characters. The first character is always a “T” (stands for time). The other characters,

depending on their positions, stand for the name of a signal or the logical status of that signal. The following is

a list of all the characters and what they stand for.

Example:TAVLL = Time for Address Valid to ALE Low.

TLLPL = Time for ALE Low to PSEN Low.

TA =0to+70

°C; V

SS =0V;VCC =5V ± 10%; -M and -V ranges.

TA = -40

°Cto+85°C; V

SS =0V;

VCC =5V ± 10%; -M and -V ranges.

TA =0to+70

°C; V

SS =0V;2.7V<VCC < 5.5 V; -L range.

TA = -40

°Cto+85°C; V

SS =0V;2.7V<VCC < 5.5 V; -L range.

(Load Capacitance for port 0, ALE and PSEN = 100 pF; Load Capacitance for all other outputs = 80 pF.)

Table 24., Table 27. and Table 30. give the description of each AC symbols.

Table 25., Table 28. and Table 31. give for each range the AC parameter.

Table 26., Table 29. and Table 32. give the frequency derating formula of the AC parameter. To calculate each

AC symbols, take the x value corresponding to the speed grade you need (-M, -V or -L) and replace this value

in the formula.

Example:

TLLIV in X2 mode for a -V part at 25 MHz:

x= 22

T= 40ns

TLLIV=2T-x=2x40-22= 58ns

VCC-0.5V

0.45V

0.7VCC

0.2VCC-0.1

TCLCH

TCHCL

TCLCH = TCHCL = 5ns.

TS80C32X2-VCKB 数据表(PDF) 43 Page - TEMIC Semiconductors

TS80C32X2-VCKB 数据表(HTML) 43 Page - TEMIC Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54

数据表下载