LTC6908-1/LTC6908-2

6

690812fa

BLOCK DIAGRA

OUT1

690812 BD

OUT2

GND

SET

3

GND

2

6

1

5

COMPLEMENTARY

OR

QUADRATURE

OUTPUTS

MUTE OUTPUT

UNTIL STABLE

POR

1-POLE

LPF

0

90/180

DIVIDE BY

16/32/64

3-STATE

INPUT DECODER

DETECT

CLOCK INPUT

WHEN A CLOCK SIGNAL IS PRESENT AT THE

MOD INPUT, DISABLE THE MODULATION.

DIVIDER SELECT

PSEUDO RANDOM

CODE GENERATOR

–

+

GAIN = 1

≈ 1.13V

MASTER

OSCILLATOR

MDAC

CLK

2

µA

2

µA

OUT

V

+

–

+

–

PI FU CTIO S

SET (Pin 1/Pin 3): Frequency-Setting Resistor Input. The

determines the oscillator frequency. The voltage on this pin

is held by the LTC6908 to approximately 1.1V below the

film resistor with a value between 20k and 400k and limit

the capacitance on this pin to less than 10pF.

supply must be kept free from noise and ripple. It should

be bypassed directly to a ground plane with a 0.1µF

capacitor.

GND (Pin 3/Pin 2): Ground. Should be tied to a ground

plane for best performance.

OUT1 (Pin 4/Pin 6), OUT2 (Pin 5/Pin 5): Oscillator Out-

puts. These pins can drive 5k and/or 10pF loads. Larger

loads may cause inaccuracies due to supply bounce at

high frequencies.

MOD (Pin 6/Pin 4): Modulation-Setting Input. This three-

state input selects among four modulation rate settings.

MOD pin turns the modulation off. To detect a floating

MOD pin, the LTC6908 attempts to pull the pin toward

midsupply. This is realized with two internal current

to ground and MOD. Therefore, driving the MOD pin high

requires sourcing approximately 2µA. Likewise, driving the

MOD pin low requires sinking 2µA. When the MOD pin is

floated, it must be bypassed by a 1nF capacitor to ground.

Any AC signal coupling to the MOD pin could potentially

be detected and stop the frequency modulation.

Exposed Pad (Pin 7/NA): Ground. The Exposed Pad must

be soldered to PCB.

(DCB Package/S6 Package)

(S6 Package Pin Numbers)