Flex 402 Two-Zone FACP

CS-2402

09/01/06

Page 2 of 2

Specifications and wiring information are provided for information only and are

believed to be accurate. Gamewell-FCI assumes no responsibility for their use.

Data and design are subject to change without notice. Installation and wiring

instructions shipped with the product shall always be used for actual installation.

For more information, contact Gamewell-FCI.

Gamewell-FCI

12 Clintonville Road

Northford, CT 06472-1610

Phone: 203-484-7161

Fax: 203-484-7118

www.gamewell-fci.com

A Honeywell Company

© 2006 Gamewell-FCI

Specifications

AC power, TB8

120 VAC, 50/60 Hz, 2.3 A.

Wire size: minimum 14 AWG (2.0 mm²)

with 600 V insulation.

Battery (sealed lead-acid only), J8

Maximum charging circuit: normal flat

charge 27.6 VDC @ 0.8 A.

Maximum battery charger capacity:

18 AH battery. Two 7 AH batteries can

be housed in the FACP cabinet. Larger

batteries require a separate battery

box such as the BB-17F.

Initiating device circuits, TB3

Alarm zones 1&2. Power-limited circuitry.

Operation: all zones Style B (Class B).

Normal operating voltage: nominal 22

VDC.

Alarm current: 15 mA minimum.

Standby current: 4 mA.

Short circuit current: 40 mA maximum.

Maximum loop resistance: 100 ohms.

End-of-line resistor: 4.7K ohm, 1/2

watt (P/N 71252).

Notification appliance circuits, TB2

One NAC on Flex 402. Power-limited

circuitry.

Normal operating voltage: nominal 24

VDC.

Maximum signaling current: 2.5 A total

with standard transform.

End-of-line resistor: 4.7K ohm, 1/2

watt (P/N 71252).

Form-C relays

Trouble relay TB5 (fail-safe). Alarm

relay TB6.

Contact ratings: 2.0 A @ 30 VAC

(resistive).

Auxiliary outputs

Resettable power, TB1

Power-limiting circuitry.

Operating voltage: nominal 24 VDC.

Maximum available current: 500 mA,

appropriate for powering four-wire

smoke detectors. Note: Total current

for resettable power and one NAC

must not exceed 3 A for the Flex 402.

Cabinet dimensions

Door: 15.342" (38.97 cm) high x 14.677"

(37.28 cm) wide x 0.375" (0.95 cm)

deep. Backbox: 15.0" (38.10 cm) high

x 14.5" (36.83 cm) wide x 3.0" (7.62 cm)

deep.

Backbox Mounting

The cabinet can be surface-mounted. The door is removable during installa-

tion by opening and lifting it off the hinges. The cabinet mounts using two

key slots at the top of the backbox and two additional 0.250" diameter holes

at the bottom.

Ordering Information

F402

Two-zone conventional FACP.

BB-17F

Battery box, required to house two batteries greater than 7

AH, to a maximum of 18 AH.

DP-FLEX

Dress panel.

TR-1-R

Trim ring for semi-flush mounting.

52194

Flex 402 Installation and Maintenance Manual.

i³™ is a trademark and Gamewell® is a registered trademark of Honeywell International Inc.