01-Jun-2002 Rev. A

Page

3 of 6

ht tp://www.SeCoSGmbH.com/

Any changing of specification will not be informed individual

Elektronische Bauelemente

SSC2127-15

Part Number

Marking

Output Voltage

Part Number

Marking

Output Voltage

7B152

1.5V

XXXX

Ordering Information(contd.)

SSC2127-25

7B252

2.5V

XXXX

SSC2127-18

7B182

1.8V

XXXX

SSC2127-33

7B332

3.3V

XXXX

Detailed Description

The SSC2127 of COMS regulators contain a PMOS pass transistor,voltage reference, error amplifier,over-current protection and thermal

shutdown.The P-channel pass transistor receives data from the error amplifier, over-current shutdown, and thermal protection circuits.

During normal operation, the error amplifier compares the output voltage to a precision reference. Over-current and Thermal shutdown circuits

become active when the junction temperature exceeds140 C, or the current exceeds 2.2A.During thermal shutdown, the output voltage

remains low. Normal operation is restored when the junction temperature drops below 120 C.The SSC2127 behaves like a current

source when the load reaches 2.2A. However, if the load impedance drops below 0.3

, the current drops back to 600mA to prevent

excessive power dissipation. Normal operation is restored when the load resistance exceeds of 0.75

.

o

o

External Capacitors

The SSC2127 is stable with an output capacitance to ground of 4.7uF or greater. Ceramic capacitors have the lowest ESR, and will

offer the best AC performance. Conversely, Aluminum Electrolytic capacitors exhibit the highest ESR, resulting in the poorest AC

response. Unfortunately, large value ceramic capacitors are comparatively expensive. One option is to parallel a 0.1uF ceramic

capacitor with a 10uF Aluminum Electrolytic. The benefit is low ESR, high capacitance, and low overall cost. A second capacitor is

The input capacitor should be at least 0.1uF to have a beneficial

effect. All capacitors should be placed in closed proximity to the pins. A "Quiet" ground termination is desirable. This can be

achieved with a "Star" connection.

Enable

When EN pin is pulled low, the PMOS pass transistor shuts off, and all internal circuits are powered down. In this state, the quiescent

source and EN

Ω

Power Good

The SSC2127 includes the Power Good feature. When the output in not within

15% of the specified voltage, it pulls low. This can

occur under the following conditions:

1. Input voltage too low.

2. During over-temperature.

3. During over-current.

4. If output is pulled up.

( Note: PG pin is an open-drain output.)

SSC2127

750mA CMOS

Positive Voltage Regulator

Ω

Ω

±