MALLORY IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP

550 MALLORY WAY, CARSON CITY, NEVADA 89701

(775) 882-6600

FAX (775) 887-4326

www.mrgasket.com

FORM #641

(REV. B) 9/99

Made in U.S.A.

Printed in U.S.A.

MALLORY COMP 9000™ DISTRIBUTOR

90 SERIES POINT TYPE

TUNE-UP AND MAINTENANCE INFORMATION

NOTE: Turning wrench

clockwise increases

dwell angle.

POINT NO. 1

Both the red point harness lead and the orange condensor lead

must connect to this point when distributor is in this point.

POINT NO. 2

Connect black point harness lead only to

this point to ensure proper distributor ad-

justment and performance.

IMPORTANT: Apply a light

film of Mallory distributor

cam grease (supplied) on

surface of cam to extend

point life.

MALLORY COMP 9000™

POINT ADJUSTMENT PROCEDURE

NOTE: If dwell meter is not available, set each

point gap at .018 – .020

OR

With connector unplugged, using the 8-cyl scale

on your dwell meter, adjust the setting to read

26º – 28º dwell angle. Proceed to Step 2 to attain

total dwell setting.

After reinserting plug connector, adjust the sec-

ond set of points to the total dwell angle setting

of 34º – 36º, again using the 6-cyl scale on your

dwell meter.

Once these two steps have been completed, you

must reset your ignition timing.

NOTE: Turning wrench

clockwise increases

dwell angle.