TLC320AC02IPM datasheet(21/84 Pages) TI

21 / 84 page

2–6

2.8

Required Minimum Number of MCLK Periods

Master with slave operation is summarized in the following sections.

2.8.1

TLC320AC02 AIC Master-Slave Summary

After initial setup and the master and slave frame syncs are separated, when secondary communication is

needed for a slave device, a 11 must be placed in the 2 LSBs of each primary data word for all devices in

the system, master and slave, by the host processor. In other words, all AICs must receive secondary frame

requests.

The host processor must issue the command by setting D01 and D00 to a 1 in the primary frame sync data

word of all devices. Then the master generates the master primary frame sync and, after the number of shift

clocks set by the FSD register value, the slave primary frame sync intervals. Then, after (B register value/2)

FCLK periods, the master secondary frame sync occurs first, and then the slave secondary frame sync

occurs. These are also rippled through the slave devices.

In other words, when a secondary communications interval is requested by the host processor as described

above:

The master outputs the master primary frame sync interval, and then the slave primary frame

sync intervals after the FSD register value number of shift clocks.

After (B register value/2) FCLK periods, the master then outputs the master secondary frame

sync interval, and after the FSD register value number of shift clocks, the slave secondary frame

sync intervals.

This sequence is shown in Figure 2–2.

The host must keep track of whether the master or a slave is then being addressed and also the number

of slave devices. The master always outputs a 00 in the last 2 bits of the DOUT word, and a slave always

outputs a 1 in the LSB of the DOUT word. This information allows the system to recognize a starting point

by interrogating the least significant bit of the DOUT word. If the LSB is 0, then that device is the master,

and the system is at the starting point.

Note: This identification always happens except in 16-bit mode when the 2 LSBs are not available

for identification purposes.

Sampling Period

(B Register Value/2) FCLK Periods

FSD Value

in SCLKs

Frame Sync

Sequence

SP1

SP2

SPn

SS1

SS2

SSn

Period Symbol

Periods shown: Each period must be a minimum of 16 SCLKs plus 2 additional SCLKs

= Master Primary Period

SP1

= 1st Slave Primary Period

SP2

= 2nd Slave Primary Period

SPn

= nth Slave Primary Period

= Master Secondary Period

SS1

= 1st Slave Secondary Period

SS2

= 2nd Slave Secondary Period

SSn

= nth Slave Secondary Period

Figure 2–2. Timing Sequence

TLC320AC02IPM 数据表(PDF) 21 Page - Texas Instruments

TLC320AC02IPM 数据表(HTML) 21 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84

数据表下载