| 数据搜索系统,热门电子元器件搜索 |
|
DG441C/D 数据表(PDF) 6 Page - Maxim Integrated Products |
|
|
|||||||||||||||||||||||||||||
DG441C/D 数据表(HTML) 6 Page - Maxim Integrated Products |
|
6 / 9 page ![]() Applications Information Operation with Supply Voltages Other Than ±15V Using supply voltages other than ±15V reduces the analog signal range. The DG441/DG442 switches oper- ate with ±4.5V to ±20V bipolar supplies or with a +10V to +30V single supply; connect V- to 0V when operating with a single supply. Also, all device types can operate with unbalanced supplies such as +24V and -5V. The Typical Operating Characteristics graphs show typical on-resistance with ±20V, ±15V, ±10V, and ±5V sup- plies. (Switching times increase by a factor of two or more for operation at ±5V.) Overvoltage Protection Proper power-supply sequencing is recommended for all CMOS devices. Do not exceed the absolute maxi- mum ratings because stresses beyond the listed rat- ings can cause permanent damage to the devices. Always sequence V+ on first, followed by V- and logic inputs. If power-supply sequencing is not possible, add two small, external signal diodes in series with supply pins for overvoltage protection (Figure 1). Adding exter- nal diodes reduces the analog-signal range to 1V below V+ and 1V above V-, but low switch resistance and low leakage characteristics are unaffected. Device operation is unchanged, and the difference between V+ and V- should not exceed +44V. Pin Description Improved, Quad, SPST Analog Switches 6 _______________________________________________________________________________________ V+ S V- D Vg Figure 1. Overvoltage Protection Using External Blocking Diodes PIN DIP/SO THIN QFN-EP NAME FUNCTION 1, 16, 9, 8 15, 14, 7, 6 IN1–IN4 Input 2, 15, 10, 7 16, 13, 8, 5 D1–D4 Analog Switch Drain Terminal 3, 14, 11, 6 1, 12, 9, 4 S1–S4 Analog Switch Source Terminal 4 2 V- Negative-Supply Voltage Input 5 3 GND Ground 12 10 N.C. Not Internally Connected 13 11 V+ Positive-Supply Voltage Input—Connected to Substrate —— EP Exposed Pad. Connect EP to V+. Do not use EP as a sole V+ connection. (Thin QFN package only.) |
|
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |