24AA01-ESLASHMC datasheet(5/34 Pages) MICROCHIP

5 / 34 page

DS21711J-page 5

24AA01/24LC01B

2.0

PIN DESCRIPTIONS

The descriptions of the pins are listed in Table 2-1.

TABLE 2-1:

PIN FUNCTION TABLE

2.1

A0, A1, A2

The A0, A1 and A2 pins are not used by the 24XX01.

They may be left floating or tied to either VSS or VCC.

2.2

Serial Address/Data Input/Output

(SDA)

The SDA input is a bidirectional pin used to transfer

addresses and data into and out of the device. Since

it is an open-drain terminal, the SDA bus requires a

pull-up resistor to VCC (typical 10 k

Ω for 100 kHz,

Ω for 400 kHz).

For normal data transfer, SDA is allowed to change

only during SCL low. Changes during SCL high are

reserved for indicating Start and Stop conditions.

2.3

Serial Clock (SCL)

The SCL input is used to synchronize the data transfer

to and from the device.

2.4

Write-Protect (WP)

This pin must be connected to either VSS or VCC.

If tied to VSS, normal memory operation is enabled

(read/write the entire memory 00-7F).

If tied to VCC, write operations are inhibited. The entire

memory will be write-protected. Read operations are

not affected.

Name

PDIP

SOIC

TSSOP

DFN

TDFN

MSOP

SOT23

SC-70

Description

—

Not Connected

—

Not Connected

—

Not Connected

VSS

Ground

SDA

Serial Address/Data I/O

SCL

Serial Clock

Write-Protect Input

VCC

+1.7V to 5.5V Power Supply

24AA01-E/MC 数据表(PDF) 5 Page - Microchip Technology

24AA01-E/MC 数据表(HTML) 5 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34

数据表下载

链接网址

24AA01-E/MC 数据表(PDF) 5 Page - Microchip Technology

24AA01-E/MC 数据表(HTML) 5 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34

数据表 下载

链接网址

数据表下载