LP3203 datasheet(8/10 Pages) POWER

8 / 10 page

Preliminary Datasheet

LP3203

LP3203 – Ver. 1.0 Datasheet

Dec.-2006

Page 8 of 10

Efficiency= 100%- (L1+L2+L3…)

Where L1、L2, etc. are the individual losses as a percentage of

Input power .although all dissipative elements in the for most

of losses: VIN quiescent current and 1

2R loss dominates the

efficiency loss at medium to high load currents. In a typical

efficiency plot, the efficiency curve at very low load currents

can be misleading since the actual power lost is of no

consequence.

1.The VIN quiescent current is due to two components:

the DC Bias current as given in the electrical

characteristics and the Internal main switch and

synchronous switch gate charge currents. the gate

charge

current

results

from switching

the

gate

capacitance

the

internal

power

MOSFET

switches .Each time the gate charge current. results

from switching the gate capacitance of the internal

power MOSFET switches. Each time the gate is

switches from high to low to high again, a packet of

charge △Q moves from VIN to ground.

The resulting △Q/△t is the current out of VIN that is typically

larger than the DC bias current. In

continuous mode.

LGATCHG=f(QT+QB)

Where QT and QB are the gate charges of the internal top and

bottom switches. Both the DC bias and gate charge losses are

proportional to VIN and thus their effects will be more

pronounced at higher supply voltages.

2. 1

2Rlosses tae calculated from the resistances of the internal

switches, RSW and external inductor RL. in continuous mode

the average output current flowing through inductor L is

“chopped” between the main switch and the synchronous

switch. Thus, the series resistance looking into the LX pin is a

function of both top and bottom MOSFER RDS(ON) and the duty

cycle (DC) as follows:

The RDS(ON) for both the top and bottom MOSFETS can be

obtained from the typical performance characteristics curves.

thus, to obtain 1

2R losses, simply add R

SW to RL and multiply

the square of the average output current.

Other losses including CIN and COUT ESR dissipative

losses and inductor core losses generally account for

less than 2% of the total loss.

LP3203 数据表(PDF) 8 Page - Lowpower Semiconductor inc

LP3203 数据表(HTML) 8 Page - Lowpower Semiconductor inc

Html Pages

1 2 3 4 5 6 7 8 9 10

数据表下载