24VL014SLASHMS datasheet(5/30 Pages) MICROCHIP

5 / 30 page

DS22129A-page 5

24VL014

2.0

PIN DESCRIPTIONS

The descriptions of the pins are listed in Table 2-1.

TABLE 2-1:

PIN FUNCTION TABLE

2.1

SDA Serial Data

This is a bidirectional pin used to transfer addresses

and data into and out of the device. It is an open drain

terminal. Therefore, the SDA bus requires a pull-up

resistor to VCC (typical 10 k

Ω for 100 kHz, 2 kΩ for

400 kHz).

For normal data transfer, SDA is allowed to change

only during SCL low. Changes during SCL high are

reserved for indicating the Start and Stop conditions.

2.2

SCL Serial Clock

The SCL input is used to synchronize the data transfer

to and from the device.

2.3

A0, A1, A2

The A0, A1 and A2 inputs are used by the 24VL014 for

multiple device operations. The levels on these inputs

are compared with the corresponding bits in the slave

address. The chip is selected if the compare is true.

Up to eight 24VL014 devices (four for the SOT-23

package) may be connected to the same bus by using

different Chip Select bit combinations. These inputs

must be connected to either VCC or VSS.

In most applications, the chip address inputs A0, A1

and A2 are hard-wired to logic ‘0’ or logic ‘1’. For

applications in which these pins are controlled by a

microcontroller or other programmable device, the chip

address pins must be driven to logic ‘0’ or logic ‘1’

before normal device operation can proceed.

2.4

WP is the hardware write-protect pin. It must be tied to

VCC or VSS. If tied to VCC, the hardware write protection

is enabled and will protect the entire array (00h-7Fh). If

the WP pin is tied to VSS the hardware write protection

is disabled. Write Protection is not available on the

SOT-23 package; for this package, write operations are

always enabled.

2.5

Noise Protection

The 24VL014 employs a VCC threshold detector circuit

that disables the internal erase/write logic if the VCC is

below 1.0 volts at nominal conditions.

The SCL and SDA inputs have Schmitt Trigger and

filter circuits that suppress noise spikes to assure

proper device operation even on a noisy bus.

Name

8-pin

PDIP

8-pin

SOIC

8-pin

TSSOP

8-pin

MSOP

8-pin

TDFN

6-pin

SOT-23

Function

User Configurable Chip Select

—

User Configurable Chip Select

VSS

Ground

SDA

Serial Data

SCL

Serial Clock

—

Write-Protect Input

VCC

+1.5V to 3.6V

24VL014/MS 数据表(PDF) 5 Page - Microchip Technology

24VL014/MS 数据表(HTML) 5 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30

数据表下载

链接网址

24VL014/MS 数据表(PDF) 5 Page - Microchip Technology

24VL014/MS 数据表(HTML) 5 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30

数据表 下载

链接网址

数据表下载