ATtiny88 datasheet(197/266 Pages) ATMEL

197 / 266 page

197

8008C–AVR–03/09

ATtiny48/88

Figure 20-7. Serial Programming and Verify

(1)

Notes:

1. If the device is clocked by the internal oscillator, it is no need to connect a clock source to the

CLKI pin.

2. VCC - 0.3V < AVCC < VCC + 0.3V, however, AVCC should always be within 1.8 – 5.5V

When programming the EEPROM, an auto-erase cycle is built into the self-timed programming

operation (in the Serial mode ONLY) and there is no need to first execute the Chip Erase

instruction. The Chip Erase operation turns the content of every memory location in both the

Program and EEPROM arrays into 0xFF.

Depending on CKSEL Fuses, a valid clock must be present. The minimum low and high periods

for the serial clock (SCK) input are defined as follows:

Low:> 2 CPU clock cycles for f

ck < 12 MHz, 3 CPU clock cycles for fck >= 12 MHz

High:> 2 CPU clock cycles for f

ck < 12 MHz, 3 CPU clock cycles for fck >= 12 MHz

20.8.1

Serial Programming Pin Mapping

VCC

GND

CLKI

SCK

MISO

MOSI

RESET

+1.8 - 5.5V

AVCC

+1.8 - 5.5V

(2)

Table 20-13. Pin Mapping Serial Programming

Symbol

Pins

I/O

Description

MOSI

PB3

Serial Data in

MISO

PB4

Serial Data out

SCK

PB5

Serial Clock

ATtiny88 数据表(PDF) 197 Page - ATMEL Corporation

ATtiny88 数据表(HTML) 197 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载