ATtiny88 datasheet(200/266 Pages) ATMEL

200 / 266 page

200

8008C–AVR–03/09

ATtiny48/88

Notes:

1. Not all instructions are applicable for all parts.

2. a = address.

3. Bits are programmed ‘0’, unprogrammed ‘1’.

4. To ensure future compatibility, unused Fuses and Lock bits should be unprogrammed (‘1’) .

5. Refer to the correspondig section for Fuse and Lock bits, Calibration and Signature bytes and

Page size.

6. See htt://www.atmel.com/avr for Application Notes regarding programming and programmers.

If the LSB in RDY/BSY data byte out is ‘1’, a programming operation is still pending. Wait until

this bit returns ‘0’ before the next instruction is carried out.

Within the same page, the low data byte must be loaded prior to the high data byte.

After data is loaded to the page buffer, program the EEPROM page, see Figure 20-8 on page

200.

Figure 20-8. Serial Programming Instruction example

Byte 1

Byte 2

Byte 3

Byte 4

Adr LSB

Bit 15 B

Serial Programming Instruction

Program Memory/

EEPROM Memory

Page 0

Page 1

Page 2

Page N-1

Page Buffer

Write Program Memory Page/

Write EEPROM Memory Page

Load Program Memory Page (High/Low Byte)/

Load EEPROM Memory Page (page access)

Byte 1

Byte 2

Byte 3

Byte 4

Bit 15 B

Adr MSB

Page Offset

Page Number

Adr

dr M

r MS

Adr

dr LS

LSB

ATtiny88 数据表(PDF) 200 Page - ATMEL Corporation

ATtiny88 数据表(HTML) 200 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载