313

process

yellow

3405

1797

1375

116

2607

652

242

2985

375

240

Embedded Power for

Business-Critical Continuity

LPX200

Enclosure

Installation Notes

LPX200 • Cover Enclosure Kit

LPX200 will fit the LPX20X-M power supplies.

Installation Instructions and Notes

1. Place the insulator over the chassis as shown.

2. Place the power supply over the insulator as shown.

3. Align the power supply to the chassis standoff.

4. Secure 4 pan head screws with washer provided with in kit as shown.

5. Place the cover over the power supply as shown.

6. Align the cover to the U-bracket countersink holes.

7. Secure 4 countersink screws provided with in kit as shown.

8. Overall dimensions: 5.9” (150mm) x 3.85” (98mm) x 1.85” (46.9mm).

9. Base plate has three sets of customer mountings:

a. Bottom mounting (4X) M3 inserts. Max. screw penetration 0.0787 (2mm)plus 2 key

ways. (See keyway detail)

b. Side mounting (4X) M3 inserts. Max. screw penetration 0.236 (6mm)

10.Ensure insulator is correctly fitted in base under PCB to maintain safety creepage

and clearances.

11.Ensure base is firmly connected to supply earth via the earth stud marked

12.When using this enclosure, ensure that relevant safety standards (e.g. EN60950) are complied

with, in respect to creepage and clearance distances, and distances through insulation.

13.All dimensions are in inches (mm)

Rev. 12.9.09_153

LPX200 Enclosure

1 of 2

OUTPUT CONNECTOR

INPUT CONNECTOR

(4X)STANDOFF

GROUND STUD

INSULATOR

Materials

•1 Base

•1 Cover

•4 M3x6mm Pan head

screws with spring washer

•4 M3x6mm countersunk

screws

•1 M4 nut

•1 M4 star washer

•1 M4 spring washer

•1 Plastic insulator sheet