DS_8024RN_020

73S8024RN Data Sheet

Rev. 1.8

13

9

OFF and Fault Detection

There are two different cases that the system controller can monitor the

OFF signal: to query regarding

the card presence outside card sessions, or for fault detection during card sessions.

Outside a card session: In this condition,

CMDVCC is always high, OFF is low if the card is not present,

and high if the card is present. Because it is outside a card session, any fault detection will not act upon

the

OFF signal. No deactivation is required during this time.

During a card session:

CMDVCC is always low, and OFF falls low if the card is extracted or if any fault

detection is detected. At the same time that

OFF is set low, the sequencer starts the deactivation

process.

The Figure 5 shows the timing diagram for the signals

CMDVCC, PRES, and OFF during a card session

and outside the card session:

rd session:

PRES

OFF

CMDVCC

VCC

PRES

OFF

CMDVCC

VCC

outside card session

within card session

OFFis lowby

card extracted

OFFis lowby

anyfault

within card

session

Figure 5: Timing Diagram – Management of the Interrupt Line

OFF

10 I/O Circuitry and Timing

The states of the I/O, AUX1, and AUX2 pins are low after power on reset and they are in high when the

activation sequencer turns on the I/O reception state. See the Activation Sequence section for more

details on when the I/O reception is enabled. The states of I/OUC, AUX1UC, and AUX2UC are high after

power on reset.

Within a card session and when the I/O reception state is turn on, the first I/O line on which a falling edge

is detected becomes the input I/O line and the other becomes the output I/O line. When the input I/O line

rising edge is detected then both I/O lines return to their neutral state.

Figure 6 shows the state diagram of how the I/O and I/OUC lines are managed to become input or output.

The delay between the I/O signals is shown in Figure 7.