SAW FILTER

HD F4521

www.shoulder.cn Tel:0755-82916880 Fax:0755-82916881 E-mail:info@shoulder.cn

Page 10 of 13

The specimen shall be passed through the reflow

furnace with the condition shown in the above

profile for 1 time.

The specimen shall be stored at standard

atmospheric conditions for 1h, after which the

measurement shall be made. Test board shall be

1.6 mm thick. Base material shall be glass fabric

base epoxy resin.

Solder ability Immerse the pins melt solder at 260℃+5/-0℃

for 5 sec.

More then 95% of

total area of the

pins

should

be

covered with solder

6.Mechanical Test

Items

Conditions

Specifications

Vibration

600-3300rpm amplitude 1.5mm

3 directions 2 H each

Drop

On maple plate from 1m high 3 times

Lead pull

Pull with 1kg force for 30 seconds

Lead bend

There shall be no

damage.

7. REMARK

7.1 Static voltage

Static voltage between signal load & ground may cause deterioration &destruction of

the component. Please avoid static voltage.

7.2 Ultrasonic cleaning

Ultrasonic vibration may cause deterioration & destruction of the

component.

Please avoid ultrasonic cleaning

7.3 Soldering

Only leads of component may be soldered. Please avoid soldering another part of

component.