LITE-ON TECHNOLOGY CORPORATOIN

P r operty of Lite-On Only

CAUTIONS

1. Application

The LEDs described here are intended to be used for ordinary electronic equipment (such as office equipment,

communication equipment and household applications).Consult Lite-on’s Sales in advance for information on

applications in which exceptional reliability is required, particularly when the failure or malfunction of the LEDs

may directly jeopardize life or health (such as in aviation, transportation, traffic control equipment, medical and life

support systems and safety devices).

2. Storage

The storage ambient for the LEDs should not exceed 30°C temperature or 70% relative humidity . It is recommended

that LEDs out of their original packaging are used within three months.

For extended storage out of their original packaging, it is recommended that the LEDs be stored in a sealed container

with appropriate desiccant or in a dessicator with nitrogen ambient.

3. Cleaning

Use alcohol-based cleaning solvents such as isopropyl alcohol to clean the LEDs if necessary.

4. Lead Forming & Assembly

During lead forming, the leads should be bent at a point at least 3mm from the base of LED lens. Do not use the base

of the leadframe as a fulcrum during forming.

Lead forming must be done before soldering, at normal temperature.

During assembly on PCB, use minimum clinch force possible to avoid excessive mechanical stress.

5. Soldering

When soldering, leave a minimum of 2mm clearance from the base of the lens to the soldering point. Dipping the

lens into the solder must be avoided.

Do not apply any external stress to the lead frame during soldering while the LED is at high temperature.

Recommended soldering condition :

Soldering iron

Wave soldering

Temperature

Soldering time

300°C Max.

3 sec. Max.

(one time only)

Pre-heat

Pre-heat time

Solder wave

Soldering time

100°C Max.

60 sec. Max.

260°C Max.

10 sec. Max.

Note.: Excessive soldering temperature and / or time might result in deformation of the LED lens or catastrophic

failure of the LED.

Part No. : LTL102SFK

Page :

6

of

8

BNS-OD-C131/A4