Optoway

SPB-9110VW-R3R5G

***********************************************************************************************************************************************************************

***********************************************************************************************************************************************************************

Tel: 886-3-5979798

Fax: 886-3-5979737

E-mail: sales@optoway.com.tw

http: // www.optoway.com.tw

8/1/2009 V1.0

2

ABSOLUTE MAXIMUM RATINGS

Exposure to absolute maximum rating conditions for extended periods may affect device reliability.

Absolute Maximum Ratings

Parameter

Symbol

Min

Max

Units

Notes

Storage Temperature

Tstg

-40

85

Operating Case Temperature

Tc

-20

85

Power Supply Voltage

Vcc

0

4

V

ESD Tolerance on all pins

1

KV HBM

Relative Humidity

---

5

95

% RH

non-condensing

Recommended Operating Conditions

Parameter

Symbol

Min

Typ

Max

Units / Notes

Power Supply Voltage

Vcc

3.13

3.3

3.47

V

Operating Case Temperature

Tc

0

70

Baud Rate

50

3000

Mb/s

Power Supply Current

Icc

150

200

mA

Receiver Specifications (0

Parameter

Symbol

Min

Typ

Max

Units

Notes

Optical

λ

RX1

1260

1310

1360

nm

1

Received Wavelength

λ

RX2

1480

1550

1580

nm

2

0

---

-18

dBm

Pathological

Sensitivity for SMPTE 424M

2.97 Gb/s

Sen

0

-20

dBm

PRBS 2

0

---

-20

dBm

Pathological

Sensitivity for SMPTE 292M

1.485 Gb/s

Sen

0

-21

dBm

PRBS 2

Signal Detect -- Asserted

Pa

---

---

-23

dBm

Transition: low to high

Signal Detect -- Deasserted

Pd

-29

---

---

dBm

Transition: high to low

Signal detect -- Hysteresis

1

6

dB

Optical Return Loss

-27

dB

Electrical

CML Output (Differential)

550

660

850

mVp-p

AC coupled output

135

ps

3, SMPTE 424M

270

ps

3, SMPTE 292M

800

ps

3, SMPTE 344M

Optical Rise Time / Fall Time

tr / tf

1.5

ns

3, SMPTE 259M

Output LOS Voltage -- Low

0

0.5

V

Output LOS Voltage -- High

2.5

Vcc+0.3

V

µA, 1 TTL unit load

2.5

Vcc+0.3

V

SCL, SDA

0

0.5

V

1.

At least 30 dB optical isolation for the wavelength 1480 to 1580 nm.

2.

At least 30 dB optical isolation for the wavelength 1260 to 1360 nm.

3.

20% to 80%, unfiltered.

MODULE DEFINITION

Module Definition

PIN 5

PIN 6

Interpretation by Host

4

SCL

SDA

Serial module definition protocol

Module Definition 4 specifies a serial definition protocol. For this definition, upon power up, SCL and SDA appear as no connector

(NC). When the host system detects this condition, it activates the serial protocol. The protocol uses the 2-wire serial CMOS E

protocol of the ATMEL AT24C01A/02/04 family of components.