www.austriamicrosystems.com

Revision 1.01

13 - 19

AS1332

Datasheet - D e t a i l e d D e s c r i p t i o n

Internal Synchronous Rectifier

To reduce the rectifier forward voltage drop and the associated power loss, the AS1332 uses an internal NFET as a

synchronous rectifier. The big advantage of a synchronous rectification is the higher efficiency in a condition where the

output voltage is low compared to the voltage drop across an ordinary rectifier diode. During the inductor current down

slope in the second part of each cycle the synchronous rectifier is turned on. Before the next cycle the synchronous

rectifier is turned off.

There is no need for an external diode because the NFET is conducting through its intrinsic body diode during the

transient intervals before it turns on.

Dynamic Output Voltage Programming

Because of the dynamically adjustable output voltage of the AS1332 there is no need for external feedback resistors.

helpful feature because the supply voltage of a PA application can be changed due to the operation mode. For

example, during the data transmission from a handset peak power is needed. In the other states the transmitting power

can be reduced to ensure a longer battery lifetime.

Shutdown Mode

If EN is set to high (>1.2V) the AS1332 is in normal operation mode. During power-up and when the power supply is

less than 2.7V minimum operating voltage, the chip should be turned off by setting EN low. In shutdown mode the

following blocks of the AS1332 are turned off, PFET switch, NFET synchronous rectifier, reference voltage source,

control and bias circuitry. The AS1332 is designed for compact portable applications, such as mobile phones where the

system controller controls operation mode for maximizing battery life and requirements for small package size

outweigh the additional size required for inclusion of UVLO (Under Voltage Lock-Out) circuitry.

Note:

Setting the EN digital pin low (<0.5V) places the AS1332 in a 0.01µA (typ.) shutdown mode.

Thermal Overload Protection

To prevent the AS1332 from short-term misuse and overload conditions the chip includes a thermal overload

protection. To block the normal operation mode the device is turning the PFET and the NFET off in PWM mode as

soon as the junction temperature exceeds 150°C. To resume the normal operation the temperature has to drop below

125°C.

Note:

Continuing operation in thermal overload conditions may damage the device and is considered bad practice.

Current Limiting

If in the PWM mode the cycle-by-cycle current limit of 1.2A (max.) is reached the current limit feature takes place and

protects the device and the external components. A timed current limiting mode is working when a load pulls the output

voltage down to approximately 0.375V. In this timed current limit mode the inductor current is forced to ramp down to a

safe value. This is achieved by turning off the internal PFET switch and delaying the start of the next cycle for 3.5us.

The synchronous rectifier is also turned off in the timed current limit mode.

The advantage of the timed current limit mode is to prevent the device of the loss of the current control.