AS8218 datasheet(39/123 Pages) AMSCO

39 / 123 page

Data Sheet AS8218 / AS8228

Revision 3.0, 31-May-06

Page 39 of 123

div5

programmable divider

Mclk

clk_1hz

div[19:0]

Parameter

Symbol

Min

Typ

Max

Unit

Notes

Input frequency range

fMclk

3.0

3.579545

4.0

MHz

Supply voltage range

VDD_BAT

2.0

3.3

3.6

Division factor

1,048,575

The setting of div[19:0] is located in the RTC registers (addresses: 9132h – 9130h)

Note:

1) The division factor n is effective on the frequency Mclk/5. It represents the actual division factor minus 1.

Example: Calculate n for oscillator frequency 3,579,545Hz. The frequency after the div5 is 715,909Hz.

Therefore, n must be 715,909 – 1 = 715,908. (Setting n = 1 means a division factor of 2)

2) n = 0 stops the clock.

Real-Time Clock (RTC)

The RTC can be directly accessed from the MCU via a dedicated interface register.

Two alarm registers are provided to indicate a certain time instance, such as the start of a new month. In that

case an interrupt is sent to the MCU. Constant frequency deviations of the crystal that is used can be trimmed

to an accuracy of better than +/-1.4ppm.

A seconds counter is provided which may be used for certain meter calculations. There is only one interrupt

output. The source of the interrupt is indicated in the Control/Status 2 register.

Time/

Calendar

Registers

Alarm

Registers

LP_DIV

Setting

Frequency

Trim

Seconds

Counter

MCU

LP_DIV

RTC

AS8218 数据表(PDF) 39 Page - ams AG

AS8218 数据表(HTML) 39 Page - ams AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载