CLL datasheet(3/4 Pages) CLAIREX

3 / 4 page

Clairex Technologies, Inc.

1301 East Plano Parkway

Plano, Texas 75074-8524

Phone: 972-265-4900

Fax: 972-265-4949

www.clairex.com

CLL Series

Photo-IC Sensors

Digital Output

Absolute maximum ratings (TA = 25°C unless otherwise stated)

storage temperature ........................................................................................................ -65°C to +150°C

operating temperature ..................................................................................................... -65°C to +125°C

lead soldering temperature

(1)............................................................................................................260°C

VCC supply voltage...................................................................................................................4.5V to 18V

VADJ (CLL130-CLL133 and CLL130W-CLL133W only) ......................................................................... 3V

VOUT (10kΩ pull-up series)

(2) ................................................................................................................ 18V

VOUT (open collector series)

(2).............................................................................................................. 30V

ISINK

(3) ................................................................................................................................................ 25mA

continuous power dissipation

(4) ..................................................................................................... 250mW

NOTES:

1. 1/16” from the case for 5 seconds maximum.

2. This rating applies when the output is in the OFF state only.

3. This rating applies when the output is in the ON state only.

4. Derate linearly 2.0mW/°C from 25°C free air to TA = 125°C.

5. CLL130-CLL133 and CLL130W-CLL133W photo-IC sensors are tested with the ADJ lead open.

6. Light source is an AlGaAs IRED with peak wavelength at 850nm.

DEFINITIONS:

• Ee (+) is the minimum irradiance required to cause the output to change state.

• Buffer: Output is HIGH when input irradiance is >Ee (+).

• Inverter: Output is LOW when input irradiance is >Ee (+).

electrical characteristics (TA = 25°C unless otherwise noted)

parameter

symbol

min

typ

max

units

test conditions

Operating supply voltage

VCC

4.5

Positive going threshold

irradiance

(6)

Ee (+)

0.005

0.025

0.05

0.25

mW/cm2

4.5V ≤ VCC ≤ 18V, ADJ open,

All non-suffix W parts.

All suffix W parts.

Hysteresis ratio

EeT (+)

EeT (-)

1.1

1.8

operate point/release point

Supply current

ICC

4.5V ≤ VCC ≤ 18V, Ee = 0

or 0.5mW, ADJ open

Total acceptance angle

ΘP

deg.

All non-suffix W parts

All suffix W parts

Gain threshold can be adjusted on the CLL130-CLL133 and CLL130W-CLL133W series by

placing a resistor between the ADJ and GND leads in accordance with the following table.

Decreasing the resistance causes the output to switch at a higher threshold level.

ADJ Resistor

Normalized Threshold

open

1.00

10k

2.00

4.7k

2.75

2.2k

3.75

5.00

Connected to GND

7.25

Clairex

Technologies, Inc.

Clairex reserves the right to make changes at any time to improve design and to provide the best possible product.

Page 3 of 4

CLL 数据表(PDF) 3 Page - Clairex Technologies, Inc

CLL 数据表(HTML) 3 Page - Clairex Technologies, Inc

Html Pages

1 2 3 4

数据表下载