STM32F100C4H7B datasheet(83/84 Pages) STMICROELECTRONICS

83 / 84 page

STM32F100x4, STM32F100x6, STM32F100x8, STM32F100xB

Revision history

Doc ID 16455 Rev 2

83/84

Revision history

Table 53.

Document revision history

Date

Revision

Changes

12-Oct-2009

Initial release.

19-Jan-2010

TFBGA64 package added (see Table 49 and Table 40).

Note 5 modified in Table 4: STM32F100xx pin definitions.

IINJ(PIN) modified in Table 6: Current characteristics. Conditions

removed from Table 25: Low-power mode wakeup timings.

Notes modified in Table 33: I/O static characteristics.

Figure 26: Recommended NRST pin protection modified.

Note modified in Table 38: I2C characteristics. Figure 27: I2C bus AC

waveforms and measurement circuit(1) modified.

Table 45: DAC characteristics modified. Figure 35: 12-bit buffered

/non-buffered DAC added.

26-Feb-2010

TIM2, TIM3, TIM4 and TIM15, TIM16 and TIM17 updated.

HDMI-CEC electrical characteristics added.

Values added to:

– Table 12: Maximum current consumption in Run mode, code with

data processing running from Flash

– Table 13: Maximum current consumption in Run mode, code with

data processing running from RAM

– Table 14: STM32F100xxB maximum current consumption in Sleep

mode, code running from Flash or RAM

– Table 15: Typical and maximum current consumptions in Stop and

Standby modes

– Table 18: Peripheral current consumption

– Table 29: EMS characteristics

– Table 30: EMI characteristics

– Table 46: TS characteristics

Section 5.3.12: I/O port characteristics modified.

Added figures:

– Figure 12: Maximum current consumption in Run mode versus

frequency (at 3.6 V) - code with data processing running from RAM,

peripherals enabled

– Figure 13: Maximum current consumption in Run mode versus

frequency (at 3.6 V) - code with data processing running from RAM,

peripherals disabled

– Figure 14: Typical current consumption in Stop mode with regulator

in Run mode versus temperature at VDD = 3.3 V and 3.6 V

– Figure 15: Typical current consumption in Stop mode with regulator

in Low-power mode versus temperature at VDD = 3.3 V and 3.6 V

– Figure 16: Typical current consumption in Standby mode versus

temperature at VDD = 3.3 V and 3.6 V

STM32F100C4H7B 数据表(PDF) 83 Page - STMicroelectronics

STM32F100C4H7B 数据表(HTML) 83 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84

数据表下载