■ CAUTIONS

1. Over voltage

A. Drive the product over the specified voltage rating (13VDC) per unit or per reel will damage

the product.

B. The product should not be used in reverse polarity.

C. It is recommended to use a power supply with overload (over-voltage, short circuit and

overheat) protection.

2. Hand soldering

A. It is recommended to use a tip temperature of 280

with a soldering iron capacity of 30W, if hand soldering of the connecting wire is required.

B. Be careful of the contaminations of hand soldering.

3. Storage & Handling

A. Open the anti-electrostatic bag only a short time before use.

B. LED is encapsulated with elastic resin and will be damaged with a external force

applied on the top surface of the LED.

C. The product should be storage in an environment with the relative humidity less than

90% RH (@30 degree C or less).

D. During installation, excess mechanical stress will damage the product. The minimum

bending radius of curvature is 5000mm. The maximum twist angle is 1 degree.

E. The product is not waterproof. Excess moisture may also damage the product.

Bright View Electronics

BVM-SFPC3 SERIES

FLEXSTRIP LIGHT

Date：2008/07/16

Page ：7 of 7

Version：F