VM-SFPC5C01 SERIES

■ CAUTIONS

1. Over voltage

A. Drive the product over the specified current/voltage rating per unit or per reel will damage

the product.

B. The product should not be used in reverse polarity.

C. It is recommended to use a power supply with overload (over-voltage, short circuit and

overheat) protection.

2. Hand soldering

A. It is recommended to use a tip temperature of 280

with a soldering iron capacity of 30W, if hand soldering of the connecting wire is required.

B. Be careful of the contaminations of hand soldering.

3. Storage & Handling

A. Open the anti-electrostatic bag only a short time before use.

B. LED is encapsulated with elastic resin and will be damaged with a external force

applied on the top surface of the LED.

C. The product should be storage in an environment with the relative humidity less than

90% RH (@30 degree C or less).

D. During installation, excess mechanical stress will damage the product. The minimum

bending radius of curvature is 5000mm. The maximum twist angle is 1 degree.

E. The product is not waterproof. Excess moisture may also damage the product.

FLEXSTRIP LIGHT

Bright View Electronics

Date：2008/07/16

Page ：7 of 7

Version-D