INT200 datasheet(9/12 Pages) POWERINT

9 / 12 page

1/96

INT200

PI-1842-050196

0 – 15 °

Dim.

inches

.395 MAX

10.03 MAX

.090-.110

2.29-2.79

.015-.021

0.38-0.53

.040 TYP

1.02 TYP

.015-.030

0.38-0.76

.125 MIN

3.18 MIN

.015 MIN

0.38 MIN

.125-.135

3.18-3.43

.300-.320

7.62-8.13

.245-.255

6.22-6.48

.009-.015

0.23-0.38

(4)

(3)

Notes:

1. Package dimensions conform to JEDEC

specification MS-001-AB for standard dual in-

line (DIP) package .300 inch row spacing

(PLASTIC) 8 leads (issue B, 7/85).

2. Controlling dimensions: inches.

3. Dimensions are for the molded body and do

not include mold flash or other protrusions.

Mold flash or protrusions shall not exceed .010

inch (.25 mm) on any side.

4. These dimensions measured with the leads

constrained to be perpendicular to package

bottom.

5. Pin 1 orientation identified by end notch or

dot adjacent to Pin 1.

Note 5

P08A

Plastic DIP-8

PI-1845-050196

0-8˚ TYP.

DIM

inches

0.189-0.197

0.050 TYP

0.014-0.019

0.012 TYP

0.053-0.069

0.004-0.010

0.228-0.244

0.007-0.010

0.021-0.045

0.150-0.157

4.80-5.00

1.27 TYP

0.35-0.49

0.31 TYP

1.35-1.75

0.10-0.25

5.80-6.20

0.19-0.25

0.51-1.14

3.80-4.00

Notes:

1. Package dimensions conform to JEDEC

specification MS-012-AA for standard small

outline (SO) package, 8 leads, 3.75 mm

(.150 inch) body width (issue A, June 1985).

2. Controlling dimensions are in mm.

3. Dimensions are for the molded body

and do not include mold flash or

protrusions. Mold flash or protrusions

shall not exceed .15 mm (.006 inch) on any

side.

4. Pin 1 side identified edge by chamfer on

top of the package body or indent on Pin 1

end.

(3)

T08A

Plastic SO-8

INT200 数据表(PDF) 9 Page - Power Integrations, Inc.

INT200 数据表(HTML) 9 Page - Power Integrations, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

数据表下载