RH5RH552B-T1 datasheet(13/29 Pages) RICOH

13 / 29 page

The above explanation is directed to the calculation in an ideal case where there is no energy loss caused by the

resistance in the external components and LxSW. In an actual case, the maximum output current will be 50

to 80% of the above calculated maximum output current. In particular, care must be taken because VIN is

decreased in an amount corresponding to the voltage drop caused by LxSW when IL is large or VIN is low.

Furthermore, it is required that with respect to VOUT, Vf of the diode (about 0.3V in the case of a Schottky type

diode) be taken into consideration.

RH5RH

Therefore it is necessary that the setting of the input/output conditions and the selection of peripheral compo-

nents should be made with ILmax taken into consideration.

•

Output Current in Continuous Conduction Mode

When the operation enters into the continuous conduction mode by increasing the IOUT, ILmin becomes equal

to Iconst (> 0), and this current always flows through the inductor. Therefore, VIN · Iconst is added to PIN in

Equation 5.

Thus, PIN=VIN · Iconst+(PON+POFF)/T=VOUT ·IOUT=POUT

When the above Equation is solved for IOUT,

IOUT=VIN

2 · tonc2/(2 · L · T · (VOUT–VIN))+VIN · Iconst/VOUT ............................................Equation 8

The peak current which flows through L · LxTr · SD is

ILmax=VIN · ton/L+Iconst ...................................................................................................Equation 9

From Equations 6 and 9, the larger the value of L, the smaller the load current at which the operation enters

into the continuous mode, and the smaller the difference between ILmax and ILmin, and the smaller the value of

ILmax.

Therefore, when the load current is the same, the larger the value of L, the easier the selection of peripheral

components with a small allowable current becomes, and the smaller the ripple of the peripheral components can

be made. In this case, however, it must be noted from Equation 6 that IOUT becomes small when the allowable cur-

rent of the inductor is small or when VIN is so small that the operation cannot enter into the continuous mode.

HINTS

RH5RH552B-T1 数据表(PDF) 13 Page - RICOH electronics devices division