Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur, including inoperability and degradation of device reliability

and/or performance. Functional operation of the device and/or non-degradation at the Absolute Maximum Ratings or other conditions beyond those indicated in

the recommended Operating Ratings is not implied. The recommended Operating Ratings indicate conditions at which the device is functional and should not be

operated beyond such conditions.

Note 2: The absolute maximum specification of the ‘SW to GND’ applies to DC voltage. An extended negative voltage limit of -10V applies to a pulse of up to 50

ns.

Note 3: ESD was applied using the human body model, a 100 pF capacitor discharged through a 1.5 k

Ω resistor into each pin.

Note 4: Typical values represent most likely parametric norms at the conditions specified and are not guaranteed.

Note 5: Min and Max limits are 100% production tested at 25°C. Limits over the operating temperature range are guaranteed through correlation using Statistical

Quality Control (SQC) methods. Limits are used to calculate National’s Average Outgoing Quality Level (AOQL).

Note 6: The value of

θ

20 to 30°C/W depending on the amount of PCB copper dedicated to heat transfer. See application note AN-1797 for more information.

12V, T

Efficiency vs I

V

30074127

Normalized Switching Frequency vs Temperature

30074104

Current Limit vs Temperature

30074103

Normalized R

30074108

www.national.com

4