Obsolete

Product(s)

- Obsolete

Product(s)

Obsolete

Product(s)

- Obsolete

Product(s)

FCC statement

SPZB260

12/15

A.1

Label instruction

Instruction manual for FCC ID labeling

Module type:

ZigBee® module

SPZB260

FCC-ID:

S9NZB260A

This intends to inform you how to specify the FCC ID of our ZigBee® module SPZB260 on

your final product.

Based on the Public Notice from FCC, the product into which our transmitter module is

installed must display a label referring to the enclosed module.

The label should use wording such as “Contains Transmitter module FCC ID: S9NZB260A

or “Contains FCC ID: S9NZB260A, any similar wording that expressed the same meaning

may be use.

It shows an example below

A.2

Special requirement for Modular application

The following requirements are fulfilled:

1.

The modular transmitter must have its own RF shielding:

The RF module used on the board fulfils the emission requirements of the FCC rules

without additional shielding.

2.

The modular transmitter must have buffered modulation/data inputs:

The module has a memory management unit inside of the IC. The processor

interfacing with the external application by means general purpose I/O (GPIO), Uart,

SPI. The processor interfaces also the RF part of the module exchanging data and

command with it. Inside the processor a flash memory is available to download the

customer application and the ZigBee® profiles.

3.

The modular transmitter must have its own power supply regulation:

The IC contains an own voltage regulation. In case of changes in the supply voltage

VCC (for example caused by temperature changes or other effects), the internal

voltage will be stabilized.

4.

The modular transmitter must comply with the antenna requirements of Section 15.203

and 15.204:

The RF module is for OEM (Original Equipment Manufacturer) integration only. The

end-user product will be professionally installed in such a manner that only the

authorized antenna is used.

5.

The modular transmitter must be tested in a stand-alone configuration:

The RF module was tested in a stand-alone configuration.

6.

The modular transmitter must be labelled with its own FCC ID number:

The RF module will be labelled with its own FCC ID number. When the module is

installed inside the end-product, the label is not visible. The OEM manufacturer is

instructed how to apply the exterior label.

Contains FCC ID: S9NZB260A