5

4546F–RKE–12/08

T5750

Figure 4-1.

Tolerances of Frequency Modulation

Using C

tances on each side of the crystal of C

crystal of C

typical with worst case tolerances of ±16.8 kHz to ±28.0 kHz results.

4.3

CLK Output

An output CLK signal is provided for a connected microcontroller, the delivered signal is CMOS

compatible if the load capacitance is lower than 10 pF.

4.3.1

Clock Pulse Take-over

The clock of the crystal oscillator can be used for clocking the microcontroller. Atmel

ATARx9x has the special feature of starting with an integrated RC-oscillator to switch on the

T5750 with ENABLE = H, and after 4 ms to assume the clock signal of the transmission IC, so

that the message can be sent with crystal accuracy.

4.3.2

Output Matching and Power Setting

The output power is set by the load impedance of the antenna. The maximum output power is

achieved with a load impedance of Z

resistive path to V

The delivered current pulse of the power amplifier is 7.7 mA and the maximum output power is

delivered to a resistive load of 475

Ω if the 0.53 pF output capacitance of the power amplifier is

compensated by the load impedance.

An optimum load impedance of:

Z

power of 5.5 dBm.

The load impedance is defined as the impedance seen from the T5750’s ANT1, ANT2 into the

matching network. Do not confuse this large signal load impedance with a small signal input

impedance delivered as input characteristic of RF amplifiers and measured from the application

into the IC instead of from the IC into the application for a power amplifier.

Less output power is achieved by lowering the real parallel part of 475

Ω where the parallel imag-

inary part should be kept constant.

Output power measurement can be done with the circuit of Figure 4-2 on page 6. Note that the

component values must be changed to compensate the individual board parasitics until the

T5750 has the right load impedance Z

the cable used to measure the output power must be calibrated out.

XTAL