HCS515 datasheet(8/38 Pages) MICROCHIP

8 / 38 page

HCS515

DS40183E-page 8

4.0

INTERFACING TO A

MICROCONTROLLER

The HCS515 interfaces to a microcontroller via a syn-

chronous serial interface. A clock and data line are

used to communicate with the HCS515. The microcon-

troller controls the clock line. There are two groups of

data transfer messages. The first is from the decoder

whenever the decoder receives a valid transmission.

The decoder signals reception of a valid code by taking

the data line high (maximum of 500 ms) The microcon-

troller then services the request by clocking out a data

string from the decoder. The data string contains the

function code, the status bit, and block indicators. The

second is from the controlling microcontroller to the

decoder in the form of a defined command set.

Figure 4-1 shows the HCS515 decoder and the I/O

interface lines necessary to interface to a microcon-

troller.

4.1

Valid Transmission Message

The decoder informs the microcontroller of a valid

transmission by taking the data line high for up to

500 ms. The controlling microcontroller must acknowl-

edge by taking the clock line high. The decoder then

takes the data line low. The microcontroller can then

begin clocking a data stream out of the HCS515. The

data stream consists of:

• START bit ‘0’.

• 2 status bits [REPEAT, Vlow].

• 4-bit function code [S3 S2 S1 S0].

•STOP bit ‘1’.

• 4 bits indicating the number of transmitters

learned into the decoder [CNT3…CNT0].

• 4 bits indicating which block was used

[TX3…TX0].

• 64 bits of the received transmission with the hop-

ping code decrypted.

Note:

Data is always clocked in/out Least

Significant bit (LSb) first.

The decoder will terminate the transmission of the data

stream at any point where the clock is kept low for lon-

ger than 1 ms. Therefore, the microcontroller can only

clock out the required bits. A maximum of 80 bits can

be clocked out of the decoder.

FIGURE 4-1:

HCS515 DECODER AND I/O INTERFACE LINES

FIGURE 4-2:

DECODER VALID TRANSMISSION MESSAGE

VDD

RF DATA

SYNC CLOCK

SYNC DATA

S0 OUTPUT

HCS515

MCLR

VSS

RF_IN

S_CLK

S_DAT

VCC

MICRO RESET

S1 OUTPUT

Decoder Signal Valid

TCLKH

TDS

Cii

TACT

TDHI

TCLA

Received String

S_DAT

TX0

TX3

RX63

REPT VLOW

CNT0

CNT3

RX0

RX1

RX62

S_CLK

Information

TACK

TCLKH

TCLKL

Transmission

HCS515 数据表(PDF) 8 Page - Microchip Technology

HCS515 数据表(HTML) 8 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

数据表下载