Only One Name Means ProTek’Tion™

www.protekdevices.com

05057.R5 2/11

Page 1

587B062LP - 587B302LP

Low PRofiLe 240v ac PoweR Line suRge suPPRessoR

DescRiPtion

The 587BxxxLP Series of 240 Volt AC Surge Suppressors is designed for use by the OEM, equipment installer and or

maintenance contractor. These modules employ a three stage technology proven to be the most cost effective and

reliable method in protecting sensitive electronic equipment from over voltage transients. This series is designed to

protect AC powered equipment from the 6,000 volt peak open circuit voltage and 3,000 Amp short circuit current as

defined in ANSI/IEEE C62.41, Category C1.

The 587BxxxLP Series offers a high degree of protection against 240 VAC EMI line noise. It is ideal for protecting 800

Volt components because the solid state TVS technology assures that the line-to-neutral voltage will not exceed 800

Volts. While the modules are designed for transient voltage protection, the advanced circuitry will also attenuate the

amplitude and slow the rate of rise of high frequency noise acting as an EMI filter. The 587BxxxLP Series includes dif-

ferential mode protection, which is effective in reducing interference from line to equipment and are effective in reduc-

ing equipment generated noise to meet FCC, VDE and CSA interference requirements.

featuRes

• Compatible with IEC 61000-4-5 (Surge): 1kA, 8/20µs, Level 4 (Line-

Gnd) & 333A, Level 4 (Line-Line)

• Meets ANSI/IEEE C62.41 Requirements

• Listed to CSA, File LR65240

• Differential and Common Mode Protection

• Low Clamping Voltage

• Nanosecond Response Time

• Long Life and Maintenance Free

• Finger Safe Connections

MechanicaL chaRacteRistics

• Low Profile Plastic Package

• Approximate Weight: 360 grams

• Flammability Rating UL 94V-0

aPPLications

• Hard Wired Equipment AC Power Protection

• Load Side Distribution Systems

• Secondary Protection for Light Industrail AC Power

Low PRofiLe

figuRe 1

tRansient voLtage thReat conDition

0

10

20

30

40

50

60

t - time - µs

4

6

2

0

figuRe 2

tyPicaL cLaMPing action of a 15a MoDuLe

0

10

20

30

40

50

60

t - time - µs

4

6

2

0

8

Figures 1 and 2 are photographs of digitized waveforms showing the typical clamping action of a 15A module. A 12 Ohm resistor is used to repre-

sent a 10A equipment load. The load is then subjected to the ANSI/IEEE C62.41 Catagory CI test conditions (6000V/3000A). These photographes

contrast the effect on equipment with and without the protector.